Friday, December 28, 2012

Framing and Air-Sealing Tips for High-Performance Walls

Subtitle:&nbsp_place_holder;

New videos from Hammer and Hand feature framer Val Darrah, who shares his techniques for building Passivhaus walls

Images:&nbsp_place_holder;

[![](http://www.greenbuildingadvisor.com/sites/default/files/imagecache/blog-river/Pumpkin Ridge Passive House.jpg)](http://www.greenbuildingadvisor.com/blogs/dept/green-building-blog/framing-and-air-sealing-tips-high-performance-walls)

In three new videos produced by Oregon builder Hammer & Hand, lead carpenter Val Darrah explains how he keeps air sealing in mind as he frames the walls for his current project, the Pumpkin Ridge Passive HouseA residential building construction standard requiring very low levels of air leakage, very high levels of insulation, and windows with a very low U-factor. Developed in the early 1990s by Bo Adamson and Wolfgang Feist, the standard is now promoted by the Passivhaus Institut in Darmstadt, Germany. To meet the standard, a home must have an infiltration rate no greater than 0.60 AC/H @ 50 pascals, a maximum annual heating energy use of 15 kWh per square meter (4,755 Btu per square foot), a maximum annual cooling energy use of 15 kWh per square meter (1.39 kWh per square foot), and maximum source energy use for all purposes of 120 kWh per square meter (11.1 kWh per square foot). The standard recommends, but does not require, a maximum design heating load of 10 W per square meter and windows with a maximum U-factor of 0.14. The Passivhaus standard was developed for buildings in central and northern Europe; efforts are underway to clarify the best techniques to achieve the standard for buildings in hot climates..

Val explains why he prefers to use a router rather than a saw when he cuts out window openings in the OSB sheathingMaterial, usually plywood or oriented strand board (OSB), but sometimes wooden boards, installed on the exterior of wall studs, rafters, or roof trusses; siding or roofing installed on the sheathing—sometimes over strapping to create a rainscreen. . He also shares his method of building window bucks out of 3/4-inch plywood.

URL: http://www.greenbuildingadvisor.com/blogs/dept/green-building-blog/framing-and-air-sealing-tips-high-performance-walls

No comments:

Post a Comment